Wireless PTT Picatinny Rail Mounting Instructions

Wireless PTT Picatinny Rail

The Picatinny rail also known as a MIL-STD-1913 railStandardization Agreement 2324 rail, or tactical rail, is a bracket on some firearms that provides a standard mounting platform for accessories and attachments. THREAT4’s Wireless PTT is Waterproof and is used for Military, SWAT and Tactical Teams, and can be used for undercover and bike operations as well as any application where the cable may interfere with the job.

Picatinny Rail

Picatinny Rail

The M4 carbine with a Picatinny rail system, Grip Pod vertical forward grip, and M68 CCO sight.

The M4 carbine with a Picatinny rail system, Grip Pod vertical forward grip, and M68 CCO sight.

Items needed to mount a Wireless PTT to the Picatinny Rail.

Picatinny 1

  1. Remove the Velcro strap from the wireless Push-to-talk; then put the Velcro aside.Picatinny 2
  2. Place the bracket horizontally over the top of the metal clip.Picatinny 3
  3. Take the metal plate and slip it under the metal backing of the wireless PTT, the lip on the metal plate should be facing up and centered.Picatinny 4
  4. Take the Picatinny mount and place it vertically on top of the bracket. The metal bar in the Picatinny rail should be facing up.Picatinny 5
  5. Secure each screw on the side of the Picatinny rail where the holes are provided.Picatinny 6
  6. Now it’s time to affix it to the rail. Loosen the circular thumb screw, this will allow you to slide the PTT onto the rail. Once it is on the rail, tighten the thumb screw so that it fits snug to the rail.Picatinny 7
Picatinny Rail:

The rail consists of a series of ridges with a T-shaped cross-section interspersed with flat “spacing slots.” Accessories are mounted either by sliding them on from one end or the other; by means of a Weaver mount which is clamped to the rail with bolts, thumbscrews or levers; or onto the slots between the raised sections.

The Picatinny locking slot width is 0.206 in (5.23 mm). The spacing of slot centers is 0.394 in (10.01 mm) and the slot depth is 0.118 in (3.00 mm). The only differences between the Picatinny rail and the similar Weaver rail are the size of these slots and the fact that they are standardized. Weaver rails have a slot width of 0.180 in (4.57 mm), but are not necessarily consistent in the spacing of slot centers. Some accessories are designed to fit on both Weaver and Picatinny rails; but most Picatinny devices will not fit on Weaver rails. As of May 2012, however, most mounting rails are cut to Picatinny standards, and many accessories come with the recoil pin cut to the Weaver-compatible diameter. Many rail-mounted accessories come with only a single recoil pin, avoiding the issue of differing slot spacing.

Transmit to Others....Share on FacebookShare on LinkedInTweet about this on TwitterEmail this to someone


Categories: Learning Centre, Military, SWAT, Tactical, Wireless

Tags: , , , , , , ,

Leave a Reply